Tail wheel support.

by

Wanted to keep this reasonably light, not perfect scale, but looks close enough when done. I can always change it! Mounting is with 2 M4 screws.

always looks horrible before cleaning.
A bit of a departure from ‘real’, but this part does get a beating.
2 M4 nuts welded in place. Top part is also U-shaped to fit between longerons, bottom U-shaped to fit carbon part.

The seat is built from 6 alu strips going front to back and 7 crosswise. Sort of like in this test. I need to think about this a bit, the center one going to the rear will have to be somewhat special.

Seat for the all important driver.