Making metal chips.

 Acroduster, CNC  Comments Off on Making metal chips.
Oct 012020
 

Finally getting the hang of producing chips in a consistent way. I think I need approx 36 pcs of the brackets you see in the second image. By the time I have those made, I’ll be an experd.

These by the way are fittings for truss-tubes in the wings. Once the wings are covered nobody will ever see them again.

Below is an image from the build process of a full-size version. The red tubes are 1″ diameter, the bolts at the bottom of the image are 1/4″ (6 mm)

All that stuff is not that big!

Brackets van be seen where red tubes connect.

My version of the brackets.

This post is following on from here.