Oct 012020
 

Finally getting the hang of producing chips in a consistent way. I think I need approx 36 pcs of the brackets you see in the second image. By the time I have those made, I’ll be an experd.

These by the way are fittings for truss-tubes in the wings. Once the wings are covered nobody will ever see them again.

Below is an image from the build process of a full-size version. The red tubes are 1″ diameter, the bolts at the bottom of the image are 1/4″ (6 mm)

All that stuff is not that big!

Brackets can be seen where red tubes connect.

My version of the brackets.

This post is following on from here.

Sorry, the comment form is closed at this time.